Troubleshooting • USB Soundcard output level low on rp3, normal on rp400
Hi,I have the following setup that I tried on my rp3 and my rp400.3A alimArturia Minifuse 1 USB Soundcard (And a 1974 Japanese SG copy, a reamp and an amp but it does not change anything) Rp...
View ArticleClik here to view.
Raspberry Pi Connect • Raspberry Pi Connect missing "Connect Via"...
I was trying to remote into my Pi and I logged into Raspberry Connect and the place where I would normally have the method I wanted to connect is not there. Is it down for maintenance, or am I doing...
View ArticleTroubleshooting • Stuck during upgrade
So fresh install, stuck during upgrade with this:Updating /etc/pam.d/vncserverUpdating /etc/pam.conf... doneLooking for font path... Any idea why and/or how to get past this?ThanksStatistics: Posted...
View ArticleGeneral discussion • Best Raspberry Pi for Everyday Use?
Hey everyone, I’m new to Raspberry Pi and really excited to start using one. I’m a student looking for a model that can handle daily tasks like web browsing, media streaming, light coding, and maybe...
View ArticleTroubleshooting • Creating a WiFi hotspot
Used to have this working fine in Debian using `brctl`, `hostapd` and `dndmasq` ,I bridged wlanE and eth1, ran hostapd on wlanE, and dndmasq on br0. All was good.Unfortunately networking has been...
View ArticleTroubleshooting • Pi zero 2w goes into reboot loop if wifi is set to Au in...
Hi There,I think I found a bug. If you set the wifi country to au it causes a reboot loop. I'm using the imager for windows and entering the wifi settings there. I have a pi zero 2w. I believe it also...
View ArticleTroubleshooting • Raspberry Pi 3B freezes with Aeotec Z-Stick Gen5 and Z-Wave...
Hello!This is mainly a note to self after taking way too long (on this forum) to find a solution to my issue:After updating my Raspberry Pi 3B (that runs Z-Wave JS UI for Domoticz, and with an Aeotec...
View ArticleTroubleshooting • unable to setup eth0 on raspberry pi 5
I have a few raspberry pi 5's which are powered using some POE hat and are powered via a cisco switch. I have installed the default debian image that has NetworkManager as the default networking...
View ArticleTroubleshooting • Raspberry Pi 5 crashing on loadup when SD card is connected
Hello everyone! I hope you all are well. Unfortunately, I've been having trouble with two Raspberry Pi 5's not getting past the initial boot whilst I have my SD Card attached.Upon startup, the Pi's...
View ArticleGeneral discussion • Switching from Labwc to LXDE/LXPanel on Raspberry Pi 5
Bonjour / Good day,With my new Raspberry Pi 5, I installed the base and now I'm using piOS Desktop (Bookworm) with Labwc. It looks like LXDE and LXPanel are already installed, but I want to properly...
View ArticleClik here to view.
General • Unable to set temporary breakpoint Function main not defined
Hi guys,I just started a new project, but I'm not able to start debugging.After start debugging I get following error message:Code: launch.json: Unable to set temporary breakpoint...
View ArticleGeneral discussion • Configuring Pi as Bluetooth Receiever
I'm tryying to set up a Raspberry Pi 4 as a bluetooth audio reciever. I have a HIFi-berry Opitcal out board and an external bluetooth adapter. All the guides I can find are near or more than 10 years...
View ArticleGeneral discussion • Why in gods name is there no reverse voltage protection...
Even if there is some on the Usb ports, there isnt any on the gpios, so i ask you, how does one manage to reverse the polarity on a usb port? The gpio pins tho, much easier, one wrong connection, one...
View ArticleInterfacing (DSI, CSI, I2C, etc.) • Switch between I2C display and HDMI -...
Hi,a while back, i put together one of these https://www.instructables.com/Making-a- ... spberry-3/ and have been enjoying it immensely since. However, the 3.5 screen is a bit "cramped" sometimes and...
View ArticleMicroPython • PIO Help in Micropython on Pi Pico
Hi All, I have recently been working on building a simple VGA gfx card, I have done one as TTL circuity, one via FPGA and now trying with the Pi Pico.I know this has been done previously, but wanted...
View ArticleTroubleshooting • Debugging OpenVPN Server on Pi4 that stopped working
I'm running an OpenVPN server on a Pi4 with Buster. It has worked correctly for several years (first configured in 2022) The OpenVPN installation is based on PiVPN.ioPi version:Code: Linux...
View ArticleInterfacing (DSI, CSI, I2C, etc.) • Library for communicating with ExpressLRS...
HelloI'm looking for a library to communicate with ExpressLRS receiver (ideally Python library) that can be used with Raspberry Pi 2/3/4/5/Zero.C++ will also work probably but the project will require...
View ArticleTroubleshooting • Headless won't connect to WiFi
Hi, I'm using a headless Raspberry pi 3, I just installed a fresh system on new SD card and it won't connect. I've tried thrice to set it up using the recommended imager, never succeed. It seems like...
View ArticleRaspberry Pi OS • ACT LED is inverted, can it be changed?
Hi,I'm used to control the onboard LEDs through the /sys/class/leds filesystem interface. That used to work just fine in older models and other devices like Orange Pi. Now I got a Raspberry Pi 5 and...
View ArticleAI Camera - IMX500 • Unable to locate package imx500-all
I have connected the AI camera to Pi 5. Running Raspberry Pi OS bookwormkavasamroot@mugam1:~ $ kavasamroot@mugam1:~ $ sudo apt update && sudo apt full-upgradeHit:1 http://deb.debian.org/debian...
View Article