Camera board • Camera alignment

Hi,

I have a v3 NoIR camera (normal) and due to the adhesive pad I can see the camera "plane" is not parallel to the board (as seen in the image).



But I will attach the camera to a fixed structure, so I can't adjust the orientation, and I need to make it parallel. And I'll have to do it to ~8 cameras, so I would prefer a relatively simple and easy system.

Since I will 3d print the structure, my first idea was to make it so when I screw the camera (with the screws going from back to front, reversing what is seen in the picture), the structure presses the metallic enclosure of the camera on the 4 corners compressing the pad where it is higher (blue circles and arrow). Is this safe? Do you think it will work?

Any other ideas?

Thanks in advance,
Pau

Statistics: Posted by paussus — Thu Mar 13, 2025 5:22 pm — Replies 0 — Views 2

---