Hi, I'm working on a small pcb that uses the Pico, and I want to add an additional USB-C port for powering it (just want to make sure I'm getting the method of powering the board correct).
I'm routing the USB VBUS pin through a 5V voltage regulator, the output through a power switch, and then that into Pico's VSYS. I'm connecting the USB GND to a GND pin on the Pico.
Will this work fine if I also plan on using the built-in USB for programming and tests?
Here's the relevant part of my schematic:
![Image]()
I'm routing the USB VBUS pin through a 5V voltage regulator, the output through a power switch, and then that into Pico's VSYS. I'm connecting the USB GND to a GND pin on the Pico.
Will this work fine if I also plan on using the built-in USB for programming and tests?
Here's the relevant part of my schematic:
Statistics: Posted by kuskus.dev — Tue Dec 31, 2024 11:39 am — Replies 3 — Views 66