Hey all! I am still new to R PI. After reading a lot of threads here on this topic I still can't figure out what I'm doing wrong. I have
- Raspberry Pi 4 IO board
- Raspberry Pi CM 4
- HQ Cam
I've made changes to the config file that now looks like his:
But when I run "rpicam-hello --list" I still get "no cameras available". I have only one camera and it is connected with the Zero cable to CAM1 port. Am I missing something ridiculously stupid?
- Raspberry Pi 4 IO board
- Raspberry Pi CM 4
- HQ Cam
I've made changes to the config file that now looks like his:
Code:
# Uncomment some or all of these to enable the optional hardware interfaces#dtparam=i2c_arm=on#dtparam=i2s=ondtparam=spi=on# Enable audio (loads snd_bcm2835)dtparam=audio=on# Additional overlays and parameters are documented# /boot/firmware/overlays/README# Automatically load overlays for detected DSI displaysdisplay_auto_detect=1# Automatically load initramfs files, if foundauto_initramfs=1# Enable DRM VC4 V3D driverdtoverlay=vc4-kms-v3dmax_framebuffers=2# Don't have the firmware create an initial video= setting in cmdline.txt.# Use the kernel's default instead.disable_fw_kms_setup=1# Run in 64-bit modearm_64bit=1# Disable compensation for displays with overscandisable_overscan=1# Run as fast as firmware / board allowsarm_boost=1[cm4]# Enable host mode on the 2711 built-in XHCI USB controller.# This line should be removed if the legacy DWC2 controller is required# (e.g. for USB device mode) or if USB support is not required.otg_mode=1[all]enable_uart=1dtoverlay=w1-gpioStatistics: Posted by nightrave — Fri Apr 12, 2024 7:40 pm — Replies 1 — Views 28