Hello everyone…I need a lot of help
I am making my second project of a Streamer with Raspberry PI5 + Volumio (last version).
In the first project I had no problems, the 7 inch display was immediately recognized by the Raspberry PI5, with the touchscreen I had no problems
For this project I bought a 12.6 inch display.
I can’t set the resolution for this display. Connected to HDMI 1, the right port next to the USB c power port
I searched in various forums for the solution to the problem also finding suggestions with similar config files but I confess my total ignorance in “programming” and the many failed attempts.I asked the seller for help but received no response
I use PUTTY with WINDOWS 7
These are the technical data of the display:
Wisecoco 12.6 inch LCD display
1920 X 515 157PPI
Support color 16.7M
Frame Rate 60Hz
model NV126B5M
SIGNAL INTERFACE Edp (2LANES)
HDMI input
No Touchscreen (I don’t use it)
https://it.aliexpress.com/item/10050083 ... pt=glo2ita
Connected to the PC with W7 it's ok
When Volumio boots, the VOLUMIO logo appears on the display (with an “unnatural” resolution), then the window that the resolution is 640 X 480, after a few seconds it goes into standby with the NO SIGNAL message.
For a moment, with these settings, I was able to see the volume image correctly
max_framebuffer_height=1920
hdmi_mode=87
hdmi_group=2
hdmi_force_mode=1
hdmi_timings=515 0 30 30 30 1920 0 18 6 6 0 0 0 60 0 66280000 3
gpu_mem=512
I hope I have written all the necessary information
Please Help me
I am making my second project of a Streamer with Raspberry PI5 + Volumio (last version).
In the first project I had no problems, the 7 inch display was immediately recognized by the Raspberry PI5, with the touchscreen I had no problems
For this project I bought a 12.6 inch display.
I can’t set the resolution for this display. Connected to HDMI 1, the right port next to the USB c power port
I searched in various forums for the solution to the problem also finding suggestions with similar config files but I confess my total ignorance in “programming” and the many failed attempts.I asked the seller for help but received no response
I use PUTTY with WINDOWS 7
These are the technical data of the display:
Wisecoco 12.6 inch LCD display
1920 X 515 157PPI
Support color 16.7M
Frame Rate 60Hz
model NV126B5M
SIGNAL INTERFACE Edp (2LANES)
HDMI input
No Touchscreen (I don’t use it)
https://it.aliexpress.com/item/10050083 ... pt=glo2ita
Connected to the PC with W7 it's ok
When Volumio boots, the VOLUMIO logo appears on the display (with an “unnatural” resolution), then the window that the resolution is 640 X 480, after a few seconds it goes into standby with the NO SIGNAL message.
For a moment, with these settings, I was able to see the volume image correctly
max_framebuffer_height=1920
hdmi_mode=87
hdmi_group=2
hdmi_force_mode=1
hdmi_timings=515 0 30 30 30 1920 0 18 6 6 0 0 0 60 0 66280000 3
gpu_mem=512
I hope I have written all the necessary information
Please Help me
Statistics: Posted by calzolaio — Tue Mar 11, 2025 8:41 pm — Replies 0 — Views 4