The raspberry pi 5 doesn't work with bltouch 3.1?
My friend has a pi4 and it works perfectly fine.
We assume it's to do with the PWM0 ports on the Pi 5 don't exist or don't act the same way
I've hooked the bltouch as follows but doesn't work:
white → GPIO0
black → GND next to GPI0
yellow → GPIO27
brown → GND
red → 5v
I've also made the pi 5 a secondary mcu to be able to control the bltouch
Is there a reason why this is different to the pi4.
Any solutions or has this been a waste of money and time?
My friend has a pi4 and it works perfectly fine.
We assume it's to do with the PWM0 ports on the Pi 5 don't exist or don't act the same way
I've hooked the bltouch as follows but doesn't work:
white → GPIO0
black → GND next to GPI0
yellow → GPIO27
brown → GND
red → 5v
I've also made the pi 5 a secondary mcu to be able to control the bltouch
Is there a reason why this is different to the pi4.
Any solutions or has this been a waste of money and time?
Statistics: Posted by sassall — Mon Feb 26, 2024 1:15 pm — Replies 0 — Views 9