Troubleshooting • CM5 Dev Kit - NVMe not detected at all

Hi there,

The dev board is running generally without any issue.
Fresh full 64bit OS installed on eMMC and booting without any issues.
Idea is to have the eMMC install with the std OS and playing around with the SSD.
But it seems not to be detected.
I set the boot config.txt param

dtparam=pciex1

but it neither shows up in the /dev folder nor by lsblk

The disk is a SanDisk Ultra M.2 NVMe that was running in a NAS. So expect partioning and formatting needed.
Did I miss out something?
Thx in advance

Statistics: Posted by Hulster — Sat Dec 21, 2024 11:37 am — Replies 0 — Views 35

---