I have a 4B that I setup with Open Media Vault and it killed 3 hard drives so I gave up on that idea. Then I decided I wanted to use it to run Frigate NVR. I flashed the SD card 3 times, twice with the latest 64bit os and once with a legacy 64bit OS. When I power it up I get the typical board activity with red power light on and the twinkle of the NIC connector. I let is go for about 30 minutes with my HDMI monitor connected and nothing displayed. Just the monitor trying to figure out the nature of the signal. When I do an IP search and scan the Pi 4 does not show. I figured since it killed three hard drives with the last use it must be no good. I have another 4B new never used. I went through the same process, flashed a new SD card 3 times and it did the same thing. Do I have the bad luck of two bad boards or am I doing something wrong? I have successfully worked 3Bs and Zero W boards.
Statistics: Posted by Czak62 — Mon Nov 18, 2024 10:58 pm — Replies 0 — Views 22