Hi! I have just received my 2 of my new Pico 2's today,
however I'm currently struggling to get any programs to run on it.
I've installed the VS Code extension, that downloaded all the SDKs and everything
but the program that just prints hello world with printf doesn't upload to the Pico.
no matter what I do it shows up as a partition on my windows PC, and in device manager it shows up as RP2350 Boot every time. I tried looking with `picotool info` to see if its detected there. but all i get is "Program Information: none".
I at first thought it might be because I did some bad soldering around the pin header, but then i took out my Pico 2 that i didn't have anything soldered to yet and i had the same issue. I've tried updating the WinUSB driver on interface 1 of the Pico 2 but that didn't help matters.
Any help or tips would be appreciated! Thanks in advance!
however I'm currently struggling to get any programs to run on it.
I've installed the VS Code extension, that downloaded all the SDKs and everything
but the program that just prints hello world with printf doesn't upload to the Pico.
no matter what I do it shows up as a partition on my windows PC, and in device manager it shows up as RP2350 Boot every time. I tried looking with `picotool info` to see if its detected there. but all i get is "Program Information: none".
I at first thought it might be because I did some bad soldering around the pin header, but then i took out my Pico 2 that i didn't have anything soldered to yet and i had the same issue. I've tried updating the WinUSB driver on interface 1 of the Pico 2 but that didn't help matters.
Any help or tips would be appreciated! Thanks in advance!
Statistics: Posted by furball.vixie — Mon Aug 26, 2024 6:55 pm — Replies 0 — Views 25