So i was looking at the datasheets, as I wanted to use the chip to make a project using infrared. However, I found the datasheets to be very confusing as in the UART section, it says
"The modem and irDA modes of the PL011 are not supported"
However, it then goes on to describe registers and configuration values for a "low-power irDA mode".
Has anyone used this in projects ? What exactly is the difference between irDA and "low-power" irDA when technically... irDA isnt supported ?
Maybe i'm just bad at reading and it's very simple, but I don't get it. Also, if anyone made use of it and has some example code to share, I'd take it too.
"The modem and irDA modes of the PL011 are not supported"
However, it then goes on to describe registers and configuration values for a "low-power irDA mode".
Has anyone used this in projects ? What exactly is the difference between irDA and "low-power" irDA when technically... irDA isnt supported ?
Maybe i'm just bad at reading and it's very simple, but I don't get it. Also, if anyone made use of it and has some example code to share, I'd take it too.
Statistics: Posted by XLuma — Fri Aug 09, 2024 3:13 pm — Replies 3 — Views 46