Good morning Peeps.
I have ten Ender 3 Pro printers going at the same time.
So I have ten tabs open on the laptop to control them.
I did not set them up originally.
My understanding is that they are all controlled wirelessly via RaspberryPi.
So how does one assign tab #6 to control Printer #6
It keeps telling me "site cannot be reached"
I've change out the RaspberryPi card on other machines before. Never had this problem.
I'm afraid this is a bit above my pay grade.
I think it has something to do with the memory chip that I put into the RaspberryPi board. But I've done that before too for other printers. Never had this problem.
I have ten Ender 3 Pro printers going at the same time.
So I have ten tabs open on the laptop to control them.
I did not set them up originally.
My understanding is that they are all controlled wirelessly via RaspberryPi.
So how does one assign tab #6 to control Printer #6
It keeps telling me "site cannot be reached"
I've change out the RaspberryPi card on other machines before. Never had this problem.
I'm afraid this is a bit above my pay grade.
I think it has something to do with the memory chip that I put into the RaspberryPi board. But I've done that before too for other printers. Never had this problem.
Statistics: Posted by Erikthred111 — Wed Aug 07, 2024 3:43 pm — Replies 0 — Views 6