I've been trying to make an Ethernet gadget using the Slave port USB with my CMIO Rpi 4 board. I've done this on other RPi boards but unable to get this to work...
The ifconfig -a shows the usb0 interface on the gadget side, however its ip link command shows NO CARRIER. The host RPi does not show any USB relevant device or network interface on its end either.
I thought I read somewhere that you have to modify the dts or kernel to get this to work???
Is anyone familiar with trying to get this working??
I'm really stuck and been pulling my hair out for a week.
Thank you!!
The ifconfig -a shows the usb0 interface on the gadget side, however its ip link command shows NO CARRIER. The host RPi does not show any USB relevant device or network interface on its end either.
I thought I read somewhere that you have to modify the dts or kernel to get this to work???
Is anyone familiar with trying to get this working??
I'm really stuck and been pulling my hair out for a week.
Thank you!!
Statistics: Posted by fla_dev — Wed Jun 05, 2024 7:47 pm — Replies 1 — Views 47